Protel dxp sp2的原理图如何导出到ORCAD?我的导出与导入过程如下

xenium

Protel dxp sp2的原理图如何导出到ORCAD?我的导出与导入过程如下

一.把PROTEL DXP的原理图保存为Orcad SDT Schematic(*.sch);

二,在ORCAD里读Orcad SDT Schematic(*.sch)文件;

但不成功,ORCAD的提示信息为:

******************************************************************************** WARNING [XLT0012] Unable to load the primary SDT Configuration file: 'D:\studywork\ProtelDXP\DRC\SDT.CFG'. WARNING [XLT0063] Window's environment variable 'ORCADPROJ' is not set. WARNING [XLT0012] Unable to load the primary SDT Configuration file: 'SDT.CFG'. ERROR [XLT0070] Translation failed. ERROR [XLT0071] Translation Notice Error(s) encountered. Please check the Session Log.

请大侠们指点,谢谢

[em06][em06][em06][em06]

markman

把整个工程保存为dsn